• Nie Znaleziono Wyników

chemical properties of metals report

N/A
N/A
Protected

Academic year: 2021

Share "chemical properties of metals report"

Copied!
3
0
0

Pełen tekst

(1)

CHEMICAL PROPERTIES OF METALS

Expriment 1. Reactions of metals with acids

Equipment: - test tubes in rack Chemicals: - diluted acids; HCl, HNO3, H2SO4

- concentrated acids; HCl, HNO3, H2SO4

- metal samples: Al, Zn, Fe, Cu

Attention! All experiments should be performer under the fume cupboard! Description of the experiment:

Clean the metal sample with sand paper up to 2 cm height. Wash it with distilled water. Pour app. 1 cm3 of each of the diluted acids into the test tube in order: HCl, HNO3 and H2SO4. Then pour app. 1 cm3 of each of the

concentrated acids into the test tube in the same order. Put the metal sample to the solution for 30 sec. and note the observations (eg. bubbles, precipitate). Rinse the sample in distilled water after each reaction.

Remember! Copper metal does not react with dilute acids. It reacts only with concentrated oxy-acids. There is no

hydrogen evolution! Sulfur or nitrogen are reduced to a lower oxidation state (NO, NO2, SO2) and appearing

bubbles are the nitrogen or sulphur oxides.

Experiment 2. Reactions of metals of various activity

Equipment: - test tubes in rack Chemicals: - solutions of salts: FeSO4,CuSO4, AgNO3

- metal samples: Mg, Al, Zn, Fe, Cu

Description of the experiment:

Clean the metal sample with sand paper up to 2 cm height. Wash it with distilled water. Pour app. 1 cm3 of each of solution to the test tube. Put the metal sample to the solution for 30 sec. and note the observations (eg. bubbles, dissolution or reduction of metal, precipitate). Rinse the sample in distilled water after each reaction.

(2)

20..../.... WIMiR Gr.

Name, surname

Subject:

CHEMICAL PROPERTIES OF METALS

Assistant signature

Expriment 1. Reactions of metals with acids

L

p Reaction course inoxidation state Change Observations, conclusions 1 Zn + HCl = 2 Zn + HNO3 = 3 Zn + H2SO4 = 4 Zn + HCl conc. = 5 Zn + HNO3 conc. = 6 Zn + H2SO4 conc. = 7 Cu+ HCl = 8 Cu + HNO3 = 9 Cu + H2SO4 = 10 Cu + HCl conc.= 11 Cu + HNO3 conc. = 12 Cu + H2SO4 conc. = 13 Al + HCl = 14 Al + HNO3 = 15 Al + H2SO4 = 16 Al + HCl conc. = 17 Al + HNO3 conc. = 18 Al + H2SO4 conc. = 19 Fe + HCl = 20 Fe + HNO3 = 21 Fe + H2SO4 = 22 Fe + HCl conc. = 23 Fe + HNO3 conc. = 24 Fe + H2SO4conc. =

(3)

Experiment 2. Reactions of metals of various activity

L

p Reaction course inoxidation state Change Observations, conclusions 1 Mg + FeSO4 = 2 Mg + CuSO4 = 3 Mg + AgNO3 = 4 Zn + FeSO4 = 5 Zn + CuSO4 = 6 Zn + AgNO3 = 7 Al + FeSO4 = 8 Al + CuSO4 = 9 Al + AgNO3 = 10 Fe + FeSO4 = 11 Fe + CuSO4 = 12 Fe + AgNO3 = 13 Cu + FeSO4 = 14 Cu + CuSO4 = 15 Cu + AgNO3 =

Cytaty

Powiązane dokumenty

On the basis of the performed investigation it was found that the biggest influence on the nucleation temperature has the aluminium content (it decreases the nucleation

As a result of the comparison of the corrosion loops width of the investigate alloys as well of the inclination angle and amplitude of the curve loops it can be

Magnesium alloys are subjected to heat treatment mostly for the purpose of improvement of their mechanical properties or as an intermediary operation, to prepare the alloy to

Purpose: Main aim of this paper are results of the optimization of heat treatment conditions, which are temperature and heating time during solution heat treatment

Purpose: In the following paper there have been the structure and properties of the MCMgAl12Zn1, MCMgAl9Zn1, MCMgAl6Zn1, MCMgAl3Zn1 magnesium cast alloy as-cast state and after a

The results of the metallographic investigations performed on the optical microscope show that the ACAlSi9Cu and ACAlSi9Cu4 cast aluminium alloys are characterised by a

% of revealed negligible (no noticeable amount) heat affect zone in opposition to magnesium alloys with aluminum concentration of 9 and 12 wt. The depth of the surface

Fig. Influence of cooling rate and aluminium concentration on latent heat of crystallization process.. to the liquidus line) as well the cooling rate (it causes an